HP Photosmart D7160 0x18a0001 – ink system

Met de beschrijving op https://h30434.www3.hp.com/t5/Printing-Errors-or-Lights-Stuck-Print-Jobs/Ink-system-failed-Error-Oxc18a0101-on-photosmart-D7160/m-p/27071#M231430

Fix your HP Photosmart D7360 (Reset Code/Master Reset)

1- Turn off power and unplug from power source.
2- Open right side of printer (looking at the front).
3- Disconnect,by pulling gently, both white flat ribbon cables off the main circuit board.
4- Plug in power source and turn printer on. Wait till you get a error message and push “Ok”.
5- Unplug power source.
6- Reconnect the flat ribbon cables by aligning and carefully pushing into the conectors on the main circuit board.
7- Plug in power source and turn printer on (Printer preparing occurred).
8- voila, the nasty error message 0xc18a0001 “Ink System has Failed” is now gone. http://www.fixya.com/support/t451942-help    THIS WORKED!!!  Don’t throw it out try this first for: Ink system failed Error:Oxc18a0101 on photosmart D7160. 

Het is best lastig de zijkant te verwijderen. Er zitten een paar schroeven in, en na het verwijderen van de schroeven zitten er weerhaakjes voor eenmalig vastzetten en niet meer losmaken. Door met beleid kracht toe te passen, is de zijkant te verwijderen zonder al te veel clips af te breken.

Een andere optie vond ik op http://www.ccl-la.com/blog/index.php/hp-photosmart-ink-system-failure-2

HP PhotoSmart “Ink System Failure” #2

January 20, 2010 by CCL_TECH
Filed under: Uncategorized 

For HP PhotoSmart and Deskjet printers without Fax capabilities, use this guide.
Are you experiencing the ink system failure on your printer? The error is
caused by air getting in the ink tubes feeding the system. This is normally
cause by refilled cartridges but can be caused by any cartridge that goes very
low on ink and then tries to reload ink. This reset procedure does have to be
performed with a full cartridge installed. The following reset procedure will
correct the issue by purging the ink tubes and flushing any air trapped in them.

This sequence works if you have a C3110, C3210 or C3310 series printer. This
reset procedure should also work on any printer without FAX capabilities.
 
Please perform the following steps in order:
1. Make sure you have new cartridges in the printer so that it can reset
2. Press down the OK and Cancel buttons down at the same time and turn the
printer
off.
3. Keep holding the buttons down until the printer turns off.
4. Release the buttons.
5. Now turn the printer on while pressing the OK and Cancel buttons. It should cycle a bit then
turn back off.
6. Turn the unit on again.
7. After the second time off/on the printer will recalibrate the ink cartridges,
this will take about 5 minutes.
8. After calibration it should be online ready to print. Print a test page to
verify operation.

You should be back up and running. If this procedure does not solve the problem
then remove the cover from the printer and check the small white gear on the end
of the ink pump. The gear can come off after heavy use, just push it back on and
then redo the reset precedure as described above.


Print this entry

Geef een reactie

Het e-mailadres wordt niet gepubliceerd. Vereiste velden zijn gemarkeerd met *